For SSMA Thread-in Connectors
| Hermetic Seal No. | Center Pin Dia | A | B | C | D | E | F | C’Bore Tool No. | Solder Tool No. |
|---|---|---|---|---|---|---|---|---|---|
| 290-06G 290-07G |
0.012 | 0.004 0.003 |
0.057 0.56 |
0.028 0.027 |
0.067 0.065 |
0.0790 0.780 |
0.098 | T-53022-2 | T-53022-5 |
| 1490-13G 1490-14G 1490-15G |
0.009 | 0.008 0.006 |
0.057 0.056 |
0.021 0.021 |
0.032 0.030 |
0.0740 0.0720 |
0.091 | T-53022-4 | T-53022-3 |
Seal Installation
- Hold seal soldering tool upright.
- Placing short end of seal center conductor into locating hole.
- Place split solder ring perform over O.D. of seal. Let rest on tool.
- Install into mounting hole keeping tool in upright position.
- Solder seal into housing.
- Remove tool and clean any residue as required.
Note: Other soldering techniques may be utilized. Other methods should still achieve proper seal, center conductor centering, and position seal front surface orthogonal to connector axis to provide 3600 of outer conductor contact for effective microwave performance.
